Spindle reset form
Here you can reset the operating hours counter after replacing a spindle..
Spindle replacement checklist
-
Switch off the energy supply (electricity) completely.
-
Make sure that the spindle shaft is absolutely stationary.
-
Remove all connections from the spindle.
-
Remove the spindle from the machine according to the instructions.
The code will be sent to the specified email
Spindel Formular V1
Checklist after spindle replacement
-
After mounting the spindle, the spindle must run in for 20 minutes. With the automatic run-in procedure, the process is carried out when the operating hours counter is reset.
-
Check the direction of rotation of the spindle with M03 (clockwise rotation).
-
Check the machine zero point "G58" with the dongle belonging to the machine. Clamp the dongle in the spindle's collet and approach the machine zero point X = "0" and Y = "0". Deviations must be corrected in the register machine parameters.
-
Clamp a milling cutter in the collet and check the tool positions. Correct deviations in the register machine parameters.
-
For machines with a camera, calibration and correction of the offset "Spindle > Camera" are required.
Send the removed spindle to SCHUNK Electroinic Solutions GmbH for maintenance or repair
